When selecting a full-contact internal floating roof, it can be easy to focus on the headline features: lightweight construction, emissions performance, installation and cost.

But the real test of an internal floating roof is how it performs over years of operation—and what happens when something goes wrong.

Not all full-contact aluminum IFRs are built the same.

HMT's ALLENTECH HC Full Contact IFR combines honeycomb aluminum construction with a focus on buoyancy, structural integrity, vapor retention and long-term maintainability.

Buoyancy Built with Redundancy

Buoyancy is one of the most important considerations when selecting a floating roof. A roof needs to remain stable even if a compartment becomes damaged or flooded.

The ALLENTECH HC is designed with a minimum 2:1 buoyancy ratio against roof dead load plus perimeter seal friction and provides approximately 350% excess buoyancy on average. The roof is also designed to remain afloat with two adjacent flotation compartments flooded.

This redundancy provides an important layer of protection when conditions aren't perfect.

Tested Before It Reaches the Tank

The difference between floating roof designs often comes down to what's happening inside the roof.

The ALLENTECH HC uses individual honeycomb aluminum modules that are completely enclosed and seal welded, creating independent buoyant compartments. Each module is pressure tested using helium leak detection before leaving the factory, helping verify compartment integrity before installation.

Built-in resealable vapor detection ports also allow the compartments to be tested again during future maintenance.

That's an important distinction when comparing IFR designs:  The ALLENTECH HC is manufactured with precision, and validated through rigorous testing.

Strength, Seams and Long-Term Performance

ALLENTECH HC's aluminum skins are 2.5 times the API minimum thickness, while the honeycomb construction provides structural strength without unnecessary weight.

The patented Hook and Pin connection creates a high-strength bolted seam between modules while helping minimize vapor losses. The connections can also be welded when additional vapor retention is required.

Since the roof is made up of individual modules, damaged sections can be repaired locally, without the need to consider replacement of the entire roof.

Don't Just Compare Roofs. Compare the Engineering.

When comparing full-contact IFR options, it's worth asking more than how much a roof weighs or how quickly it can be installed.

Ask:

  • How much reserve buoyancy does the roof have?
  • What happens if a flotation compartment floods?
  • How are flotation compartments tested?
  • Can they be tested again after installation?
  • Does the roof have inherent rigidity and vapor retention?
  • Can individual damaged modules be replaced?

These questions can reveal significant differences between roofs that may appear similar at first glance.

A full-contact IFR is a long-term investment in the performance of your storage tank. The ALLENTECH HC is designed with redundancy, testing and maintainability built into the roof—not added as an afterthought.

When you're comparing full-contact IFRs, don't just compare the materials or the price.

Compare the engineering behind them.

Desktop Tablet Mobile